·        Before using the iron, remove it completely from its packing case and packaging.

·        Put the item on a plane and stable surface near a socket (max. Mt. 1,5).

·        It is recommended to keep the iron on the non-inflammable carpet  (supplied with the kit).

·        Insert the small metal staff (supplied with the kit) in point (2). Position the cable connecting iron and boiler.

·        Unscrew cap (1) and fill the boiler with max.  1,2 Lt. of water. Make sure it does not spill over. 

·        Put the plug (6) into the outlet, switch on boiler (4) and iron (3). If the two switches are lighted, it means that they are working.

·        Turn the temperature regulation knob of the iron plate  (7) to the position “cotton" °°° (as you find it on the iron knob).

·        Wait until the boiler warning light is out (4)  (after about 10 min.). While ironing, the light normally lights up by itself.

·        The machine is ready to be used.

·        Press the steam button. (8)

·        If, while ironing, the steam stops and the water button (5) lights up, it means that the boiler water is almost out. In order to start ironing again, switch the boiler off (4), unscrew slowly its cap (1); be sure before removing it, that the iron does not release steam any more, by pressing the iron steam knob (8). Disconnect the plug (6) and then, after a few minutes, fill the boiler with warm water.

·        After that, when you first press the steam button, you might notice a decrease in pressure. This happens because the system tubes are full of water. In order to have plenty of steam, wait until the button light is out.

·        Do not leave the machine unattended while the plug is in the socket.

·        Caution: the iron reaches very high temperatures and is still very hot even 15 minutes after you turn it off. So you might get burned, even if the system is switched off.  

·        The plug has to be pulled out before you fill the boiler with water. 

·        While ironing and until 15 minutes after the ironing, the iron plate is very hot and therefore dangerous- please, avoid touching it.

·        While using the machine do not unscrew or remove the cap. Before removing it, be sure that the brush does not release steam anymore. 

·        The machine has a special thermic device. Non qualified- people can not remove this.

·        The boiler cap must be replaced only with original parts.

·        If you need to let your ironing system be controlled or fixed, please contact only authorised technical assistance centres (for further information please call: tel. 0302141199 or visit our web site: www.lelit.com ).